Free in-home measure and quote - PGT, CGI and CWS impact lines compared on your actual openings, style by style
ECO Window Systems Impact Garage Doors: The Lighthouse Point Owner’s Guide
We stock and install ECO Window Systems-compatible impact garage doors in Lighthouse Point, with typical installed pricing from $2,800 to $4,600 depending on door size, wind-load rating, and hardware configuration. Most ECO Window Systems impact garage door replacements in Lighthouse Point are completed in a single day once the measured survey is approved. Most homeowners discover a problem when the door hangs unevenly, the opener strains, or the door fails to seal after a storm - often traced to a failed torsion spring, warped track, or degraded impact glazing seal.
Which ECO Window Systems Models This Applies To
ECO Window Systems produces impact-rated garage doors across several series, and the parts are not interchangeable between lines. The ECO 5000 Series uses 2-inch track hardware with wind-load ratings to 170 mph, while the ECO 7000 Series steps up to 3-inch heavy-duty track and reinforced struts for larger openings. Check the model sticker on the interior face of the door panel or the track mounting bracket - it will read “ECO-5XXX” or “ECO-7XXX” followed by a size code.
We carry both OEM ECO Window Systems hardware and verified aftermarket equivalents from Clopay and Amarr where the spec matches. For the 5000 Series, we stock torsion springs rated at 10,000 cycles in 0.225-inch and 0.250-inch wire sizes. For the 7000 Series, the spring diameter jumps to 2.25 inches with a higher cycle rating. The aftermarket springs we use meet the same ASTM E1996 impact standard but cost 15 to 20 percent less. One compatibility gotcha: ECO Window Systems switched from standard-lift to high-lift track geometry in 2019 production. A 2018 door and a 2020 door of the same nominal size can require different cable drum sets. We verify this on site before ordering anything.
Sightline Windows & Doors Lighthouse Point is an independent service provider, not affiliated with ECO Window Systems.
Signs Your ECO Window Systems Impact Garage Doors Is Failing

- The door slams shut or falls too fast. This points to a failed or fatigued torsion spring. In Lighthouse Point, we regularly see spring failures at 7 to 9 years rather than the rated 10,000 cycles, because salt air from the Intracoastal accelerates corrosion inside the spring coils.
- The opener motor runs but the door barely moves. Usually a stripped gear in the opener or a binding roller on a corroded track section. The 7000 Series’ heavier panel weight exaggerates this symptom when a single roller seizes.
- Visible gaps around the door perimeter after closing. The rubber impact seal has hardened or the bottom astragal has separated. In canal-front homes near the Lighthouse Point Marina, UV exposure plus salt spray degrades these seals faster than inland Broward County.
- Loud popping or grinding during operation. A cracked hinge, failing bearing in a roller, or a track section pulling away from the jamb bracket. The 5000 Series’ lighter-gauge track is more prone to jamb bracket fatigue on wide double-car openings.
- The door reverses immediately after touching the floor. The travel limit is out of adjustment, or the safety sensor has shifted. On ECO doors with integrated impact-rated glass panels, extra panel weight can compress the floor seal enough to trigger a false obstruction signal.
Before
AfterReplacement Cost & What’s Included
For ECO Window Systems impact garage door replacement in Lighthouse Point, installed pricing runs $2,800 to $4,600 for a standard 16-by-7-foot double door. Single-car 9-by-7-foot doors start around $2,200 installed. The range reflects wind-load rating (HVHZ vs. standard Miami-Dade), insulation package, window insert configuration, and whether the opener requires upgrade to handle increased panel weight.
Every quote itemizes parts and labor separately. The measured survey you keep, the written scope, and the final invoice are the same document - Haven Clause 1. Work carries our 365-Day Done Right Promise. We also stock PGT, CGI, and CWS hardware for mixed-product homes.
| Component | Price Range |
|---|---|
| Torsion spring pair (5000 Series) | $280 - $380 |
| Torsion spring pair (7000 Series) | $340 - $460 |
| Complete track and hardware set | $520 - $780 |
| Impact-rated panel section replacement | $440 - $680 |
| Full door replacement, installed | $2,800 - $4,600 |
DIY or Call Us?

There is exactly one safe DIY check: verify that the photo-eye sensors are aligned and unobstructed. If the LED on each sensor glows steady, they are not your problem.
Everything else on an impact-rated garage door carries genuine injury risk. Torsion springs store enough torque to cause serious harm or death if unwound incorrectly. The 7000 Series springs in particular run at higher initial tension. Track alignment requires releasing that tension first. We have responded to calls in Lighthouse Point where a homeowner’s track adjustment attempt bent the section beyond repair, turning a $340 spring job into a full door replacement.
We do not provide step-by-step spring or cable instructions. What we do: arrive with the right spring already on the truck, verify the model year and lift geometry, and complete the swap with the door secured in open position. Measure twice, write it down, then we talk price. Call (754) 600-8907 to schedule your free estimate.
FAQs
In coastal Broward County, expect 12 to 18 years for the door assembly and 7 to 10 years for the torsion spring set, depending on proximity to salt air and maintenance frequency. Call (754) 600-8907 for an exact quote on replacement - estimates are free.
Torsion springs and impact seals are wear items; repair is not practical or safe. Track sections, hinges, and rollers can sometimes be repaired if caught early, but we replace them if corrosion is present. Call (754) 600-8907 for an exact quote - estimates are free.
A torsion spring replacement takes 90 minutes to two hours. A full door replacement requires four to six hours, including removal, jamb inspection, and new door hang and balance. Call (754) 600-8907 to schedule your free estimate.
We stock torsion springs, cables, rollers, and track hardware for both the 5000 and 7000 Series on every service vehicle. Full door panels and custom-size orders require one to two business days. Call (754) 600-8907 to confirm availability for your model.
Written by Sonia Raman, Owner, Sightline Windows & Doors Lighthouse Point at Sightline Windows & Doors Lighthouse Point, serving Lighthouse Point and nearby areas.










Before
After
Before
After
Before
After