Sliding & Patio Doors in Lighthouse Point - Free Measure, Exact Written Quote

Trusted Sliding & Patio Doors for Lighthouse Point Homeowners

Sliding and patio door installation in Lighthouse Point typically runs $2,800-$8,500 depending on size, impact rating, and frame material, with most projects completed in one to two days. Sightline Windows & Doors Lighthouse Point has installed and replaced more than 18,000 openings since 2012 under the Haven Standard, and every job starts with a measured survey the customer keeps and ends with a documented photo record. Call (754) 600-8907 to schedule your free estimate; live phone coverage is available 24/7.

Call (754) 600-8907

Lighthouse Point presents specific challenges for sliding and patio door performance. The salt air off the Intracoastal Waterway accelerates corrosion on non-impact hardware, and the city’s strict wind-borne debris requirements mean any new installation must meet Florida Building Code TAS 201, ASCE 7, or HVHZ standards depending on your exact property line. We’ve measured openings from the yacht club neighborhoods along the water to the interior streets near Sample Road, and we’ve found that older aluminum frames in this zip code often show pitting within eight to ten years of installation. Our technicians are background-checked, uniformed, and identified by license number before arrival; Haven Clause 3 means the person at your door is the person on the record.

What Our Sliding & Patio Doors Service Includes

Patio Doors

A patio door is any door system that opens onto a deck, pool area, or backyard space, typically using a sliding, swinging, or folding operation. In Lighthouse Point, we see the highest demand for sliding configurations because they preserve floor space in the compact ranch and mid-century homes common east of Federal Highway. We measure the rough opening to 1/16 inch, specify the product by performance tier and price range from our eight manufacturer lines, and the written quote you receive is the same document our installer uses on site.

Impact Sliding Glass Doors

Impact sliding glass doors combine laminated glass, reinforced frames, and multi-point locking to resist wind-borne debris and forced entry without requiring shutter deployment. Every impact-rated unit we install in Lighthouse Point carries a Miami-Dade Notice of Acceptance or Florida Product Approval, and we verify the label against the permit application before ordering. We’ve specified PGT and CGI impact sliders for waterfront properties along the Coral Ridge Country Club area where the design pressure rating must exceed 50 psf, and we’ve used CWS and ES Windows for interior Lighthouse Point homes where the requirement drops but the customer still wants the security benefit.

Sliding Glass Door Replacement

Replacement becomes necessary when the existing unit shows seal failure, frame corrosion, roller collapse, or operational binding that lubrication cannot resolve. In Lighthouse Point, we regularly find original 1980s and 1990s aluminum sliders with failed thermal breaks and single-pane glazing that cannot be brought to current energy code. Our replacement process includes full frame removal, sill pan inspection for water intrusion, and installation of a new unit with documented flashing details; the photo record shows before, during, and after conditions.

Impact French Patio Doors

Impact French patio doors use hinged panels that swing inward or outward, offering wider clear openings than sliding systems and a traditional sightline that some Lighthouse Point homeowners prefer for formal living areas. These units require precise squareness in the rough opening because any racking will cause the panels to bind or the multi-point lock to misalign. We’ve installed impact French doors from Therma-Tru and ViewLux in homes near Lighthouse Point Park where the customer wanted maximum glass area with operable ventilation; the measured survey includes a plumb-and-level reading we share in writing.

Screen Door Installation

Screen doors for sliding and patio systems use aluminum or fiberglass mesh in a rolling or sliding frame to allow ventilation while excluding insects. In Lighthouse Point, we see rapid screen deterioration from salt corrosion on cheaper aluminum mesh, so we typically specify fiberglass or stainless options from our manufacturer lines. Installation includes track alignment, roller adjustment, and mesh tension verification; if we’re pairing a screen with a new impact door, the screen frame is ordered from the same manufacturer to ensure color and profile match.

Brands We Service for Sliding & Patio Doors

We’ve specified and installed hundreds of PGT sliding and patio door systems across Lighthouse Point and our other service areas in Broward County since 2012, and we maintain direct access to their current catalog including the WinGuard and EnergyVue product families. PGT’s vinyl and aluminum impact sliders dominate the Florida market for good reason: the interlayer specification, frame reinforcement, and hardware options are documented and repeatable, which matters when we’re writing a price that cannot change. We’ve also installed CGI sliding doors in waterfront Lighthouse Point properties where the architect specified narrow sightlines and the customer needed the higher design pressure ratings available in CGI’s commercial-grade framing.

CWS and ES Windows round out our most commonly specified lines for this market. CWS offers competitive pricing on vinyl impact sliders for interior Lighthouse Point homes where the design pressure requirement is moderate, and ES Windows provides aluminum options with thermal break technology that performs well in the salt air environment. Whether you have PGT, CGI, CWS, ES Windows, or any other make currently installed, we can service, repair, or replace it; our free second opinion applies to any written estimate you’ve received from another contractor. Bring us their scope and we’ll review it at no charge.

Before

After

Signs You Need Sliding & Patio Doors Right Now

• Visible moisture or fog between glass panes. Seal failure allows humid Lighthouse Point air into the insulated glass unit, permanently degrading the thermal performance and obscuring the sightline. This condition cannot be repaired; the glass unit or entire door must be replaced, and delaying it increases cooling load and frame corrosion risk.
• Difficulty rolling or locking the door. Worn rollers, bent tracks, or frame settlement cause the operable panel to drag, jump, or refuse to latch. A door that won’t lock is a security exposure, and forced operation will eventually damage the handle set or multi-point locking mechanism, turning a roller replacement into a full hardware overhaul.
• Frame corrosion, pitting, or powdery residue. Salt air accelerates oxidation on aluminum frames that lack proper anodizing or coastal-grade finish. Once pitting penetrates the surface protection, the frame section loses structural integrity and water intrusion into the wall cavity becomes likely, especially during Lighthouse Point’s summer storm season.
• Air infiltration or temperature stratification near the door. Failed weatherstripping, warped panels, or degraded frame seals allow conditioned air to escape and unconditioned air to enter. In Florida’s cooling-dominated climate, this shows up as higher electric bills and uneven temperatures in the room; a blower door test during our survey will quantify the leakage.
• Shutter deployment fatigue or code non-compliance. If you’re still installing hurricane panels or accordion shutters over a non-impact patio door, you’re adding annual labor and cost that a single impact-rated replacement eliminates. Current Florida Building Code requires impact protection or rated shutters for all glazed openings in the HVHZ; we verify your property’s exact requirement during the measured survey.

Our Sliding & Patio Doors Process - Step by Step

1. 1
   Measured survey and written scope. Our technician arrives at your Lighthouse Point home with a laser measure, level, and camera. We record rough opening dimensions to 1/16 inch, note plumb and square conditions, identify the existing frame type and any water damage, and photograph the installation environment. You receive a copy of this survey before we leave; it becomes the basis for the written quote.
2. 2
   Product specification by opening requirements. We select from our eight manufacturer lines based on your design pressure requirement, energy performance target, aesthetic preference, and budget. The specification includes U-factor, SHGC, frame material, hardware finish, and screen type; nothing is “dealer’s choice” or left to warehouse availability.
3. 3
   Written price before any work starts. Haven Clause 1 governs this step: the quote you receive is line-itemed, fixed, and cannot differ from the measured survey. We do not estimate and adjust later. If you have a competitor’s written estimate, we offer a free second opinion review.
4. 4
   Permit application and scheduling. We pull the permit for all Lighthouse Point installations requiring one, and we schedule the work only after permit approval. Our technician arrives on the confirmed date with the specified product, verified crew credentials, and installation documentation.
5. 5
   Installation, inspection, and documented completion. We remove the existing unit, inspect and repair the rough opening as needed, install the new door per manufacturer specifications with photo documentation of flashing and fastening details, and leave the site clean. The final invoice matches the written quote, and you receive a documented photo record of the completed work. The 365-Day Done Right Promise is stamped on every job; if it’s not done right, we make it right.

How Much Does Sliding & Patio Doors Cost in Lighthouse Point?

Sliding & Patio Doors Near Lighthouse Point - Our Service Area

We install and replace sliding and patio doors throughout Lighthouse Point and the surrounding Broward County communities, including Sliding & Patio Doors in Deerfield Beach to the north and Sliding & Patio Doors in Pompano Beach to the south. Typical response time for a measured survey in Lighthouse Point proper is within two business days; Deerfield Beach and Pompano Beach properties are usually scheduled within the same window. We also regularly service Oakland Park, Fort Lauderdale, Boca Raton, Coral Springs, Parkland, Margate, Tamarac, Lauderhill, and Lauderdale Lakes. The salt air and HVHZ requirements are consistent across this corridor, and our product specifications are adjusted by exact address rather than by city name.

Frequently Asked Questions - Sliding & Patio Doors in Lighthouse Point

Schedule Your Sliding & Patio Doors Service in Lighthouse Point Today

Call (754) 600-8907 to schedule your free measured survey and written estimate. You’ll receive a documented scope before any work is discussed, a fixed price that matches that document, and a completed job with photo evidence under the 365-Day Done Right Promise. Live phone coverage is available 24/7; your call is answered by a person, not a queue.

Written by Sonia Raman, Owner at Sightline Windows & Doors Lighthouse Point, serving Lighthouse Point, Deerfield Beach, Pompano Beach, and surrounding Broward County communities since 2012.